|
ASSEMBLE THE UNIT.
PLACE THE UNIT INTO THE JAR. THE RODS SHOULD NOT TOUGH THE BOTTOM OF THE JAR. THE RODS SHOULD BE AT LEAST
1/4 INCH OFF THE BOTTOM. IF NOT, REMOVE THE UNIT FROM THE JAR. SCREW THE NUTS ON THE BOTTOM OF THE LID DOWNWARD
EQUAL AMOUNTS ON BOTH RODS. THEN RUN THE TOP NUTS DOWN ONTO THE LID. KEEP THE LID LEVEL BY ADJUSTING THE BOTTOM
AND TOP NUTS. CHECK THE DEPTH OF THE UNIT AGAIN. ONCE THE UNIT IS THE PROPER FIT, REMOVE THE TOP NUTS, WASHERS
AND SPACER. APPLY GLUE AROUND THE RODS, BREATHER TUBE AND CENTER "TEE". REPLACE THE WASHERS SPACER AND NUTS AND
TIGHTEN THEM DOWN.
MIXING THE WATER.
REMOVE THE UNITS FROM THE JARS. FILL THE JARS TO WITHIN 2 IN OF THE TOP. ADD 1 TABLESPOON
OF BAKING SODA. REPLACE THE UNITS IN THE JARS AND TIGHTEN THE LIDS. TAPE THE TWO JARS TOGETHER WITH A PIECE
OF THIN WOOD BETWEEN THE TWO JARS. MEASURE THE LENGTH OF TUBING NEEDED TO CONNECT THE IRRIGATION TEE TO THE 90* ELBO
OF THE TWO JARS. PUT ON THE 1/2 TUBING. (IT SHOULD FIT SNUG. YOU MAY WANT TO SECURE IT WITH A HOSE CLAMP. I DONT
USE THE CLAMPS.)
NEXT, ADJUST THE BUBBLER CAP SO THAT JUST A SMALL AMOUNT OF AIR CAN BE SUCKED THRU THE CAP. APPLY GLUE AROUND THE
BREATHER TUBE AND INSERT THE BUBBLER CAP INTO THE TUBE. IF IT FITS LOOSELY, REMOVE THE CAP AND APPLY SOME GLUE ON THE
BOTTOM OF THE CAP AND RE INSERT IT INTO THE TUBE. ALLOW IT TO DRY. NEXT, TAPE THE TWO JARS TOGETHER WITH A THIN PIECE
OF BOARD BETWEEN THEM. NOW FIND A PLACE TO SET THE TWO JARS.
NEXT, FIND A PLACE
FOR POSITIONING OTHER JARS, TIE A PIECE OF # 10 GAGE HOUSE WIRE AROUND THE NECK OF THE JAR AND LEAVE ABOUT 1 1/2
IN OF WIRE STICKING OUR. MAKE THIS WIRE INTO A HOOK AND FIND A PLACE TO HANG IT. I HUNG
THREE OF MINE ON THE FIRE WALL.
CLICK HERE FOR PAGE 7
|
